Skip to main content
#
 
Monday, February 22 2016

One of our builders in Queensland sent through some photos of his 3.6m Ripple tender which was built from the Dufllex foam kit. This is the same design as the one we built for another client in Qld also built in Duflex foam. This is the widened version of the original 3.6m Ripple as per BSF, the plywood boat in Tassie. 

This Ripple is fitted with an in-built fuel tank as well as a few optional extras. The owner couldn't wait and took the boat out for sea-trials unpainted! The raw Duflex boat looks quite unusual but at least he knows it will float!

We will return with more photos when the boat is fully finished...

 

Posted by: Spirited Designs AT 06:56 am   |  Permalink   |  2 Comments  |  Email
Comments:
More photos please, and much larger than these thumbnails please, thanks
Posted by Gerben on 02/23/2016 - 12:49 AM
No problem, just email us and we can send you more info?
Posted by Spirited Designs on 02/23/2016 - 06:39 AM

Post comment
Name
 *
Email Address

Message
(max 750 characters)
*
* Required Fields
Note: All comments are subject to approval. Your comment will not appear until it has been approved.

Boat Designs and Kits | Spirited News 

POWER-SAIL
Stow-Away
CrossOver

CONTACT

rss feedemail usour twitterour facebook page

P: (+61) 02 4981 8288
 

Disclaimer  Copyright © 2013 Spirited Designs. All Rights Reserved.